Skip to main content

Welding Alloys supplies wear parts for cement plant in Argentina

Published by
World Cement,


Welding Alloys Argentina has manufactured and delivered a key set of wear parts for the classifier section of an FLSmidth OK 36.4 Vertical Roller Mill, all completed to the customer’s drawings and technical specifications.

Manufactured at their IntegraTM workshop in San Nicolás near Buenos Aires, the parts included a new 5000 mm diameter x 2760 mm high, fine separator section complete with full set of vanes. The section was manufactured in 2 x halves for later assembly on the customer’s site with vanes made from 13 sheets of 6+4 Hardplate 100 and flanges from 16mm 450HB through hardened plate.

Also included were the lower cone section manufactured from 8 sheets of 8+6 Hardplate 100, the upper cone section from 11 sheets of 10+4 Hardplate 100 and the discharge tube manufactured from 8+5 Hardplate 100, all flanged with 450HB through hardened plate.

Read the article online at: https://www.worldcement.com/europe-cis/06012022/welding-alloys-supplies-wear-parts-for-cement-plant-in-argentina/

You might also like

 
 

Embed article link: (copy the HTML code below):


 

This article has been tagged under the following:

European cement news